If you have no cash and cannot afford to buy a new bike fishing rod holder, you can easily make your own at home. The process is straightforward and easy to understand. Here are steps to help you make your own holder:

Cut a PVC

The first step is to look for PV and cut them into 8 inch pieces.

Prepare the end caps

The next step is to take 2 rubber caps and cut a hole on each of them using a sharp knife. The cut pieces should be kept for later use.

Attach your hangers to the rack

Firstly, mark your PVC and place them aside.  Take a flat plat and put five holes on it and match each of the two end of the PV to the plat holes. Screw the conduit hang using a machine and then screw on the nut.  The same should be done on the other side

Connect the bracket to the end-plugs

The end plugs are amazing. Their main purpose is to stabilize the rod holder. So what you need to do is to cut a piece of flat plater, and put 4 holes in them. Place a bend at the center to make it easy for the PVC to get in. unscrew the end plug wing and put the piece of flat plat. The same should be done on the other side.

The license plat holder should slide out

Note that the plate holder is a plug, designed to decorate. It is made of plastic, so, this affects the rigidity of the entire design. However, you can minimize vibration and movement of the holders will preserve the lifespan of the plug.

Mount the tool up and get to work

Place your rods in position and start fishing

Best fishing rod racks